Home ยป Plumbing. Water supply. Sewage

Installing washbasins, sinks, sinks and drinking fountains

Ceramic sinks single or group is mounted on cast iron brackets attached to the wall with screws.

First, mark out the template holes for mounting brackets, then drilled holes (installing brackets on a stone or concrete wall) and insert them into the dowels or vinyl chloride tube. Then install the brackets, check their level and secured with screws. When install basin is necessary to pin protruding upper arm was a hole in the lower side of the plane of the basin.

General view of the installation basin with dvuhoborotny siphon and hidden laying water and sewage pipes from the floor shown in Fig.

Installing washbasins, sinks, sinks and drinking fountains

Set washbasin with back without overflow and siphon-revision :
1 - discharge pipe on the concrete floor slab;
2 - outlet pipe to the sewer standpipe;
3 - waterproofing

 

Washbasin combined with metal siphon outlet with a diameter of 32 mm. If you are installing the release to a wash basin did not break when tightening the nuts under the top ring, and reduce the need to put a rubber ring. When install basin with trap-release audit is attached to the pipe length of 110 mm. At one end of the threaded sleeve and the other end to the size razbortovyvayut siphon. For screwed pipe coupling. Razbortovanny end of the sleeve, wrapped resin strands and topped with stucco, is inserted into the trap and at the same time establish a wash basin on the bracket. After installation and alignment of the sink clean excess putty.

When a group setting washbasins can be combined total discharge steel pipe with a diameter of 40 mm with a common cast iron siphon.

When assembling taps, depending on the type of valve, punched one, two and three holes existing in the lower side of the rear shelf heated. These Nacala size of 28 x 28 mm made to a depth equal to 3/4 the thickness of the shelves. When installing the wall-mounted faucet hole in the back shelf washbasins not punched.

Set shells

If installed under the sink siphon dvuhoborotny-audit, then the upper edge of it should be at a height of 645 mm from the floor.

Discharge pipe lay on the floor. The sink is attached to the wall with screws that are screwed into the dowels.

Set shell as follows. First, mark out holes for mounting the sink, then they drilled in the stone, concrete or other wall and insert dowels. Wrap the release of the shell resin strands and insert it into the siphon on Surikova putty. Then privertyvajut sink to the wall with screws and remove excess putty Surikov. If separate backrest shell, it is attached to the wall after installation of the sink bowl. Tap eyeliner to the sink can be positioned above, below or to the side.

Installing sinks

Installing washbasins, sinks, sinks and drinking fountains

Set the iron sink

 

Shows an installation on brackets iron sinks into two compartments MCH-2. To protect against possible ingress of liquid waste (in the case of clogging sewage systems) in the premises catering sink should have between output and siphon air gap of 20-30 mm. When installing sanitary devices for wrapping screws used screwdrivers.

Installing drinking fountains

Installing washbasins, sinks, sinks and drinking fountains

Installing the Wall drinking fountain :

1 - pipe d = 15 mm, 2 - descent

 

Apply floor and wall drinking fountains. These plumbing device equipped with nozzles for drinking, have poured out a bowl for receiving water and its discharge into the sewer. In addition, drinking fountains equipped with pressure regulators maintain a constant height irrespective of the oscillations of the jet of water pressure on the network.

The figure shows the wall-mounted drinking fountain with pedal draining. For mounting cup used dowels with nut. Issue bowl connected to a U-shaped trap, located inside the device.

full version